Has anyone been doing anything about the upside down fillets on the foot rest parts? I know some support, slowing down, or maybe some additional cooling here would help. But I don’t think they’d turn out perfect either way.
Curious if people use these as is, or if folks have been reprinting them?
I use it as is. I have tried supports on it but it doesn’t help much. Good thing is that’s the back side so its not really seen. Because of that I haven’t worried about it. I think that is one of the things that @MakeGood_Noam is working on in V2. But for now we just roll with it.
I print with painted on supports
I, too, print as is. I’ve only done one TMT but the curves were a lot better than the one you pictured. Not perfect, but better.
It’s better with supports, but still not great. As it’s the back of the footrest, I just run with it
Thanks everyone, I’ll try with some painted on supports and see if I can get it to clean up a bit.
