I for the life of me can’t figure out if I’m installing the straps correctly. They do not seem to hold at all.
I can’t tell in the pic… did you feed it back through the square clip after the buckle and it still comes off?
1 Like
I am stupid I’m sorry. It didn’t even cross my mind to feed it through there.
1 Like
The first one is definitely for learning… I got held up a few times assembling 
2 Likes
Go the opposite direction on this part. And then like @BentNotBrokn mentioned make sure you go back through the slide
1 Like
The build videos here How to Build – MakeGood Design were very helpful for me. I can’t tie knots worth a darn, so I wouldn’t have figured it out without that.
2 Likes
Working on straps now. The video goes pretty quick and I can’t really see what’s going on.
What are the two wide belts for? Which go where? The build doc doesn’t list out explicitly.
It would be good if the build document had lengths of each strap and where they go.
The wide straps are for the waist belt and storage strap
I did this in a past post:
First there are only 8 straps:
The shoulder straps and foot straps are exactly the same, I use the best two for the shoulders.
The two 30mm wide straps are for the lap belt and storage in back. The slightly longer of the two is for the lap belt.
Then the long thin (19.5mm) is for the harness that goes under the seat with the lap belt.
When I feed the lap belt and harness under the seat, I keep the lap belt on the inside and the harness on the outside.
2 Likes