Printing in Sport Mode on Bambu A1

General
1

I am currently printing my first Mobility Trainer, and the total print hours for all plates is going to take 424 hours. The tires alone are showing 36 hours for one plate.

Is this correct? I am printing the files from Makerworld and have not changed a thing. On the website, it says print time is 200-250 hours.

Would it be safe to bump my print speed up to sport mode? I tried it on one plate and it took two hours off the print time, but I changed it back because I didn’t want to mess anything up.

1 Like
2

I’m at around 370 hours on a P1S. not sure how much faster it is than an A1, but i’d say you are in line.

I have no idea how anyone is getting 200-250 unless they are omitting the time to print the wheels 4x and the tires 2x. I checked the times on a H2S with a 0.6 nozzle and couldn’t even get to 250…

3 Likes
3

This sounds correct. I print on h2s and h2c and my tires in one plate take approx 3.25 days. Total point time is somewhere in the 400 hour range.

2 Likes
4

I was really hoping to see some savings with the H2S as then I could more easily justify one, but being the same, It’s harder to get there.

2 Likes