Could you create some wheels with dinosaurs that will look like they are running away from a T-Rex that I plan on attaching to the chair just behind the wheel? Excuse my poor attempt at creating an example using gifs and screenshots. 
3 Likes
I’ve been swamped lately but @Nonny might be able to get you fixed up! She is much better at it than I am anyways 
Thanks for the vote of confidence! I will take a look and see what I can do!
1 Like
It doesn’t need to be anything crazy.
1 Like
I should have asked this earlier, are you limited on how many colors?
Finally getting a chance to sit down and look at it.
And I’ll create two files- a left and a right so they’re ‘running’ in the forward direction.
8 colors and the 4 piece wheels, not the 2 piece.
I’m not 100% sure if this is what you had in mind? Let me know and I’ll create the file and upload it to the drive.
I think the most on each piece is 5 colors. You can change them around and add more.
1 Like
I think the dinos (within the same wheel) need to be facing opposite directions of each other. So as the wheel spins they are still facing forward. As the are now. The one on bottom when the wheel gets spun would be facing backwards.
1 Like
Maybe I’m misunderstanding?
If they face opposite directions, they will look like the bottom pics while spinning
Ah I see now. I was imagining both having their feet towards the center. So yeah the image on the bottom would be upside down…but right side up when it rotates back on top…aaaaaah I don’t know what I prefer. Haha
No matter what, at some point, someone is going to be upside down.
Here is another version, but again, theres upside down dinos appearing to run backwards.
3 Likes
I think that is what he was going for. It will look like the Dinos are running.
1 Like
If I am following him correctly, this is what he was going for
Yeah this is what I was envisioning.
1 Like
Awesome!!
I’ll upload the file when I get home in about an hour.
Sorry for the confusion!!
1 Like
OK, they’re on the drive! This one did NOT cooperate with my graphics software, so let me know if you have any trouble!
Please, PLEASE watch the first couple layers of each plate, just to make sure they print correctly.
There are 4 plates, 2 for the left and 2 for the right.
1 Like
Ok I will give them a download and check them out. Much more entertaining than me putting away my laundry right now.
2 Likes
Finally getting to print the wheels. I think I made a bad color choice with the tpu. Isn’t what I was imagining.
I like the color choice!!
And the Dino looks great!
1 Like